Reduced price! View larger

Esdee Super Antifouling Paint Red

Check your delivery options 


New

It is a high quality single pack fast drying antifouling paint topcoat designed to be used as a topcoat for underwater surfaces of boats/ships/in sea where growth of barnacles & other types of marine fouling organisms takes place. It has good resistance to various types of fouling. Recommended for vessels/ships pling near the coastal area.

Rs. 921

-11%

Rs. 1,035

Type Tin free Anti-fouling paint pigmented with Cuprous oxide.
FeaturesSingle pack fast drying antifouling paint topcoat for various types of boats/ships/vessels.
Recommended UseThis is designed to use as a topcoat for underwater surfaces of boats/ships/in sea where growth of barnacles & other types of marine fouling organisms takes place. It has good resistance to various types of fouling. Recommended for vessels/ships pling near the coastal area.
Product Data
Colours Red
Volume Solids 57% ± 3%.
FinishSmooth, Satin
Recom. DFT/Coat80 - 150µ
Recommended CoatsTwo
Surface PreparationAll surfaces to be coated should be clean, dry & free from contamination.
Oil & grease must be removed in accordance with SSPC-SP-1.
Surface must be washed with fresh water prior to painting so as to remove salt & other contaminants.
Proper/suitable primer should be applied before application of this finish paint.
For FRP type substrates : Remove all foreign contaminants by solvent wiping, dry the surface thoroughly, emery with 180# paper, clean this surface properly.
Apply one coat of Super E-guard Rusthide prior to this finish Coat. 
Drying Time at 30˚C
and RH 70%
Surface dry : 20-30 min.
Hard dry       : Overnight
Full cure       : 7 days.
Flash Point> 21˚C
Application Data 
Application By Airless spray, Conventional spray or brush
Mix the paint well before use.
If settling observed, loosen the settled material with the help of hand stirrer followed by power driven stirrer for quick homogenous mixing.
Based on method of applictaion, add appropriate thinner & mix it till uniform.
Strain the material through 80-100# mesh before application.
Surface temperature must be at least 3˚C above dew point but not above 50˚C
Recom. ThinnerSyncoat thinner ST49A
Thinner IntakeBy Airless spray           : upto 5-15% max.
By Conventional spray : 5-20% max by vol.Excessive thinning will lead to lower film build up & more number of coats needs to be applied.
By Brush                       : upto 10% max.
Application Details For Airless Spray application, use standard airless equipment having pump ration 50:1 ,tip size 0.43-0.53mm (0.017-0.021 inch) application tip pressure = 110-160 kg/cm².
Performance Data (after Full cure as a system)
Adhesion Excellent on prepared primed MS/FRP surface.
Shelf Life 6 months in a closed container at normal room temperature.
Packing 4 Ltrs & 1 Ltr (will take a minimum of 15 days for delivery) 
ImagePriceReferencePack SizeAdd to cart
- Rs. 921-1 Ltr
- Rs. 3,683-4 Ltrs
Add to cart

Related Products